Clutch Switch: Service and Repair

Clutch Pedal Assembly:

REMOVAL
1. Disconnect the battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Disconnect the Clutch Pedal Position (CPP) switch electrical connector.
3. Remove the CPP switch locknut.
4. Remove the CPP switch.

INSTALLATION
1. To install, reverse the removal procedure.
2. Tighten the CPP switch locknut to 14-18 Nm (10-13 lb ft).