Driver's Side

REMOVAL






1. Disconnect the battery ground cable. Wait one minute for the driver side air bag module backup power supply to deplete.

NOTE: When battery voltage is removed from the powertrain control module (PCM), all learned values will be cleared and reset to predetermined values. When battery voltage is restored to the PCM, the vehicle may exhibit certain driveability concerns. It will be necessary to drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.






2. Remove the two driver side air bag module bolts.

NOTE: Make sure the front wheels are in a straight-ahead position to ensure alignment of the air bag sliding contact.






3. Disconnect the (A) air bag sliding contact electrical connector and the (B) horn electrical connector.






4. Remove the driver side air bag module.

INSTALLATION










To install, reverse the removal procedure.