Quick Test 2.0 - Set Up

1. Connect New Generation STAR (NGS) Tester 007-00500 or equivalent to data link connector (DLC).
2. Vehicle and Tester Preparation. Prepare to run OBD II procedures:
- Gearshift lever in Park (P).
- Engine at operating temperature.
- Apply parking brake.
- Block wheels.
- Turn ignition switch to the OFF position.
- Verify that the proper program card is inserted in the NGS.
- Connect J1962/16 way DCL cable adapter to the NGS.
- Connect NGS DCL cable adapter securely into the vehicle's data link connector.
- Turn the ignition switch to the ON position or start vehicle if necessary.

NOTE: If the NGS does not communicate with the PCM, refer to Powertrain Management.

3. The NGS is ready to communicate with the PCM.