Auxiliary

REMOVAL
1. Raise vehicle on hoist.

Auxiliary Cooler:

2. Remove four screws and separate power steering fluid cooler from transaxle auxiliary fluid cooler.
3. Loosen two hose clamps and disconnect transaxle fluid cooler tubes from transaxle auxiliary fluid cooler.
4. Remove two nuts, two bolts and transaxle auxiliary fluid cooler from radiator core support.

INSTALLATION
1. To install, reverse Removal procedure noting the following:
2. Tighten nuts and bolts to 5-6 Nm (45-53 inch lbs.).
3. Check transaxle fluid level when installation is complete.