With Column Shift

REMOVAL
1. Disconnect battery ground cable.
2. Remove three screws and upper steering column shroud.
3. Insert a scratch awl into the access hole located in the bottom of the lower steering column shroud. Push in on the ignition lock cylinder release pin and rotate the ignition lock cylinder clockwise to the RUN position and remove ignition lock cylinder from the steering column tube.
4. Remove the lower steering column shroud.
5. Unsnap and slide transaxle range selector lever boot up toward the end of the transaxle range selector lever.





6. Using a standard drift punch and hammer, tap the transaxle range selector lever pin out of steering column and remove transaxle range selector lever from vehicle.

NOTE: If equipped with transmission control switch on transaxle range selector lever, disconnect electrical connector at bottom of steering column, remove wiring with transaxle range selector lever.

INSTALLATION
1. To install, reverse removal procedure.