Assembly

Connector Placement:

1. Install solenoids and tighten to 9-12 Nm (80-106 inch lbs.). Refer to the Connector Placements image for proper orientation of shift solenoid connectors.

Bottom Pump Vane Support Ring:

2. Install bottom pump vane support ring.





3. Install pump rotor with small inside diameter counter bore facing up.





4. Install seven vanes in pump rotor.

NOTE: Shiny portion of vane blade is installed toward outer vane support.

Outer Vane Support:

5. Install outer vane support.





6. Install top pump vane support ring.

Side Seal Support:

7. Install new side seal support.
8. install new pump bore ring side seal.

Vane Support Retaining Pin:

9. Install outer vane support retaining pin.





10. Install bore spring between case and tab on outer vane support.

O-ring Service:

11. Install new rubber O-ring in groove in outer vane support. Then, install metal O-ring retainer.

Pump Gear Alignment:

12. Install pump cover on pump housing and install retaining bolts. Tighten bolts evenly to 9-12 Nm (80-106 inch lbs.).

NOTE:
^ Use the pump assembly shaft to align the pump gears while installing the pump cover.
^ Make sure that pivot pin is flush with or below the surface of the main control valve body side of the pump assembly.

AX4S Check Balls: Pump Assembly Housing - Check Balls, Oil pump body:

13. Install four check balls and one relief valve.

Valve Body Guide Pins And Bolts:

14. Position valve body separator plate with bonded gasket on pump housing. Insert Valve Body Guide Pin Set T86P-70100-A and Valve Body Guide Pin T86P-70100-B. Then, install two Torx(r) bolts. Tighten bolts to 9-12 Nm (80-106 inch lbs.). Remove guide pins.
15. Position main control valve body on pump.

Valve Body Guide Pins:

16. Insert Pump Body Guide Pins T86P-70370-A and Valve Body Guide Pin T86P-70100-C.
17. Install two valve body-to-pump retaining bolts and tighten to 9-12 Nm (80-106 inch lbs.). Remove guide pins.