With AX4S Transmission
REMOVAL1. Raise and suitably support vehicle on hoist.
2. Remove front tire and wheel assemblies.
3. Remove both halfshafts from vehicle.
4. Install the Front Cover Seal Remover T74P-6700-A and 5 1/2 inch forcing screw (from tool kit T88T-6701-A) into LH differential seal.
5. Screw the Front Cover Seal Remover T74P-6700-A and forcing screw into the metal seal protector using a 1 inch box wrench.
NOTE: The differential fluid seal is a two-piece seal constructed of an outer metal protector and inner rubber seal.
6. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the outer metal seal protector is removed. Remove the metal seal protector from the tool and discard.
7. Install Front Cover Seal Remover T74P-6700-A and forcing screw into the seal portion using a 1 inch box wrench.
8. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the seal portion is removed and discard the seal.
9. Install Front Cover Seal Remover T74P-6700-A and 5 1/2 inch forcing screw (from tool kit T88T-6701-A) into RH differential seal.
10. Screw the Front Cover Seal Remover T74P-6700-A and forcing screw into the metal seal protector using a 1 inch box wrench.
NOTE: The differential fluid seal is a two-piece seal constructed of an outer metal protector and inner rubber seal.
11. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the outer metal seal protector is removed. Remove the metal seal protector from the tool and discard.
12. Install Front Cover Seal Remover T74P-6700-A and forcing screw into the seal portion using a 1 inch box wrench.
13. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the seal portion is removed and discard the seal.
INSTALLATION
1. Install LH differential fluid seal using Output Seal Replacer T86P-1177-B.
2. Install RH differential fluid seal using Output Seal Replacer T86P-1177-B with Output Seal Replacer Pilot T94P-77001-JH.
3. Install both halfshsfts into vehicle.
4. Lower vehicle.