Removal

NOTE: The power steering pump is serviced as an assembly. If any service is required the entire power steering pump assembly must be replaced.

Part 1 Of 2:

Part 2 Of 2:

1. Disconnect battery ground cable.
2. Remove drive belt.
3. Remove generator.
4. Drain and remove radiator coolant recovery reservoir.
5. Remove power steering return hose from power steering pump and drain the fluid into a clean container.
6. Remove power steering pressure hose from power steering pump and drain the fluid into a container.
7. Remove idler pulley from power steering pump support.
8. Remove power steering bracket mounting bolt located under belt tensioner mounting.
9. Remove two retaining nuts from power steering bracket mounting studs, remove both mounting studs, and pull off power steering pump support with power steering pump attached.
10. Clamp power steering pump support with power steering pump attached into a vise.






11. Remove power steering pump pulley from power steering pump shaft using Steering Pump Pulley Remover T69L-10300-B.
12. Remove three mounting bolts retaining power steering pump to power steering pump support and remove power steering pump from power steering pump support.