Drive Pulley: Service and Repair

REMOVAL
1. Loosen, but do not remove, four water pump pulley retaining bolts while drive belts are still tight.
2. Remove accessory drive belt.
3. Remove four bolts and pulley from water pump.

INSTALLATION
1. Position water pump pulley on water pump hub and install four bolts loosely.
2. Hand-tighten four water pump pulley retaining bolts.
4. Install the drive belt and drive belt tensioner.
5. Tighten water pump pulley retaining bolts to 20-30 Nm (15-22 ft. lbs.).