Finish Panel - Console Center

SPECIAL SERVICE TOOL(S) RECOMMENDED
Radio Removing Tool T87P-19061-A

REMOVAL
1. Remove console panel, if equipped.
2. Insert Radio Removing Tool T87P-19061-A into integrated control panel face plate. Push tools in approximately 38 mm (1.5 inches) to release retaining clips.

CAUTION: Do not use excessive force when installing radio removing tool, as this will damage retaining clips and make integrated control panel removal difficult.







3. Apply a light spreading force on tools and pull integrated control panel out of instrument panel.












4. Disconnect wiring connectors and automatic temperature control sensor hose and elbow, if equipped.
5. Remove screws and console center finish panel.

INSTALLATION












1. Follow removal procedure in reverse order.