Removal

1. NOTE: Refer to the illustrations following this procedure while performing the following steps.

Remove screw securing front side member moulding to inner surface of front wheel well.

2. Remove pushpins securing moulding to lower inner edge of rocker panel.

3. NOTE: Some retainers will pull-out of the moulding downstanding flange and remain in the sheet metal holes. Use pliers to peel-out retainers. The moulding downstanding flange will be damaged. Removed mouldings and retainers cannot be reused. Install a new moulding to the vehicle.

Grab moulding at front wheel well and pull moulding away from vehicle to disengage upper retainers.

4. Grab moulding at rear wheel well and pull moulding away from vehicle to disengage upper retainers.