Active Anti-Theft Alarm System

1. Verify the customer's concern by duplicating the condition.
2. Inspect to determine if one of the following mechanical or electrical concerns apply:

VISUAL INSPECTION CHART

Mechanical
^ Damaged luggage compartment door lock cylinder.
^ Damaged door lock cylinder(s).

Electrical
^ Open fuses: Power distribution box: Fuse 21 (15 A), Fuse 19 (30 A), Fuse 22 (15 A).
^ Open maxi fuses: Power distribution box: Maxi Fuse 1 (40 A), 4 (30 A), 3 (40 A) and 5 (40 A) for passive anti-theft system.
^ Open fuses: Fuse junction panel: Fuse 28 (15 A), Fuse 23 (5 A), Fuse 27 (10 A), Fuse 20 (5 A), Fuse 6 (15 A), Fuse 26 (15 A).
^ Loose connections.
^ Corroded connections.
^ Damaged switches.
^ Damaged relay(s).

3. If the inspection reveals obvious concern that is readily serviced, correct the concern before continuing with Inspection and Verification.
4. If the concern remains after the inspection, connect the Rotunda New Generation Star (NGS) Tester 007-00500 or equivalent to the Data Link Connector (DLC) located beneath the instrument panel to perform the Data Link Diagnostics Test. If the NGS responds with NO RESPONSE/NOT EQUIPPED for the Remote Anti-theft Personality (RAP) module, go to Pinpoint Test A. A: No Communication With RAP Module
If the Data Link Diagnostic test is passed for the RAP module, retrieve continuous Diagnostic Trouble Codes (DTCs) and execute self test diagnostics.
5. Enter PID/DATA Monitor and record to retrieve last alarm triggers. Record all eight alarm events (PID: AL__EVT1 through AL__EVT8).
6. If self test is passed and no DTCs are retrieved, go to Symptom Chart. Active Anti-Theft Alarm System (RAP)
7. If DTCs are retrieved, go to RAP Module DTC Index. RAP Module Diagnostic Trouble Code Index
8. If the RAP Module cannot be accessed by the NGS tester, go to Pinpoint Test A. A: No Communication With RAP Module

Rotunda Service Bay Diagnostic System (SBDS(R)) 001-00001 may also be used to diagnose this system.