Gearshift Stabilizer Bar, Replacement

1. Remove gearshift lever boot. Remove two bolts retaining gearshift stabilizer bar to case cover.
3. Raise vehicle on hoist.
4. Remove center underbody heatshield.
5. Remove transmission gearshift rod and clevis from transaxle.
6. Remove nut retaining gearshift stabilizer bar to bracket at RH transaxle support insulator.
7. Remove gearshift stabilizer bar from vehicle.
8. To install, reverse Removal procedure. Tighten gearshift stabilizer bar stud nut to 47-63 Nm (35-46 ft. lbs.).