Removal and Replacement
REMOVAL and INSTALLATION1. Remove Air Cleaner (ACL) outlet tube.
2. Disconnect engine control sensor wiring from Intake Air Temperature (IAT) sensor.
3. Loosen engine ACL outlet tube clamp and remove one engine intake air resonator from Mass Air Flow (MAF) sensor.
4. Remove retaining nuts and bolt for the other engine intake air resonator from the throttle body and intake manifold. Remove engine intake air resonator from throttle body and intake manifold.
5. If required, remove IAT sensor from engine intake air resonator.
6. To install, reverse removal procedure. Tighten engine air resonator retaining nut and bolt to throttle body and intake manifold to 8-12 Nm (71-106 lb-in). Tighten engine ACL outlet tube clamps to 2.7-5.4 Nm (24-48 lb-in).