Lever, Removal

REMOVAL
1. Raise vehicle on hoist.
2. Remove nuts and center underbody heat shield.
3. Disconnect shift cable and bracket from gearshift range selector lever stud.
4. Remove four nuts retaining bracket.
5. Remove bracket with transaxle shift cable and bracket connected and position out of way.
6. Lower vehicle.
7. With screwdriver, carefully pry bezel from console assembly.
8. Lift gearshift lever out of console assembly to access transmission control switch wiring harness connector.
9. Disconnect gearshift lever wiring harness connector and remove gearshift lever.

INSTALLATION
1. Connect gearshift lever wiring harness connector.
2. Lower gearshift lever into console assembly and install on front floor pan.
3. Snap bezel into place on console assembly.
4. Raise vehicle on hoist.
5. Install bracket and four retaining nuts. Tighten nuts to 16-22 Nm (12-16 ft. lbs.).
6. Connect shift cable and bracket to gearshift selector lever stud.
7. Install center underbody heat shield and nuts.
8. Lower vehicle.