Horn Switch: Service and Repair

REMOVAL
1. Remove driver's side air bag.

WARNING
- ALWAYS WEAR SAFETY GLASSES WHEN SERVICING AN AIR BAG VEHICLE AND WHEN HANDLING AN AIR BAG.
- THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY POSITIVE CABLE MUST BE DISCONNECTED FOR ONE MINUTE TO DE-ENERGIZE THE BACKUP POWER SUPPLY PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.







2. Remove four head screws retaining horn switch to steering wheel.

NOTE: Retaining screws are spring loaded and insulated. Be careful not to lose components.

3. Disconnect two wires (one each side) to horn blow switch.
4. Carefully pull horn blow switch straight outward from steering wheel. Remove horn blow switch.

INSTALLATION
1. To install, reverse removal procedure.