Rear

Fig. 47 Rear ABS Sensor Removal:

REMOVAL
1. Remove the rear seat cushion.
2. Disconnect the rear anti-lock brake sensor connector. Feed the connector through the hole in the floorpan.
3. Raise and support the vehicle.
4. Remove the rear anti-lock brake sensor wiring from the routing brackets.
5. Remove the rear anti-lock brake sensor mounting bolt and the rear brake anti-lock sensor.

INSTALLATION
1. Install the rear brake anti-lock sensor and the mounting bolt. Tighten the mounting bolt to 10 Nm (7 ft. lbs.).
2. Position the rear anti-lock brake sensor wiring into the routing brackets.
3. Insert the rear anti-lock brake sensor connector through the opening in the floorpan.
4. Lower the vehicle.
5. Connect the rear anti-lock sensor connector.
6. Install the rear seat cushion.