Disconnecting the Tester

CAUTION: Do not attempt to pry off connectors with a screwdriver. This will damage the connector and could result in a transaxle concern.

1. Disconnect transmission tester from transaxle connector.
2. Reinstall vehicle wiring harness. Verify connection by pulling up on the harness.
3. Reinstall all heat shields that were previously removed.
4. Disconnect transmission tester power cable from vehicle.
5. Erase all DTCs using procedures described in Powertrain Management.
6. Rerun On-Board Diagnostics (OBD) to receive a pass code (P1111).
7. Verify that the customer concern has been eliminated.