Spring Lock Coupling

REMOVAL

Fuel Tube Clip:

1. Remove clip from spring lock coupling.






2. Position Spring Lock Coupling Disconnect Tool D87L-928o-A for 3/8 inch tube or D87L-9280-B for 1/2 inch tube or equivalent onto coupling. Make sure that tool can enter cage opening to release the garter spring.






3. Push the spring lock coupling disconnect tool into the cage opening to release the female fitting from the garter spring.






4. Pull the coupling male and female fittings apart.







5. Remove the spring lock coupling disconnect tool from the disconnected spring lock coupling.

NOTE: Inspect coupling for missing or damaged O-rings. If either O-ring is damaged both O-rings must be replaced. Replace O-rings or garter springs with the appropriate replacement parts only.






6. Clean fittings with solvent.

INSTALLATION






1. Lubricate the O-rings with clean engine oil.

Garter Spring:

2. Insert male fitting into female fitting and push together until garter spring is engaged.
3. Pull on fittings to ensure coupling engagement.






4. Install clip to spring lock coupling.






5. Make sure clip is correctly installed.