With Automatic Transmission

REMOVAL
1. Apply brake pedal several times to exhaust all vacuum in the system.
2. Disconnect the brake warning indicator switch connector.
3. Remove brake tubes from primary and secondary outlet ports of brake master cylinder.
4. Remove two nuts retaining brake master cylinder to power brake booster assembly.
5. Slide brake master cylinder forward and upward from vehicle.

INSTALLATION
1. Position brake master cylinder as an assembly on studs on power brake booster assembly.
2. Install retaining nuts. Tighten retaining nuts to 21-29 Nm (15-18 ft. lbs.).
3. Install primary and secondary brake tubes to brake master cylinder outlet ports. Tighten to 14-22 Nm (10-18 ft. lbs.).
4. Connect brake warning indicator switch connector.
5. Fill brake master cylinder with specified brake fluid to 4.0 mm (0.16 inch) below MAX line on brake master cylinder reservoir. Use high performance DOT-3 brake fluid.
6. Bleed brake system.
7. Apply brakes several times, then check for external hydraulic leaks.