Hoisting and Body Support

WARNING: THE FOLLOWING HOIST RESTRICTIONS MUST BE OBSERVED TO PREVENT VEHICLE DAMAGE OR PERSONAL INJURY.

1. Position vehicle over hoist. Turn ignition switch to OFF position and turn off air suspension switch located in luggage compartment on RH side.
2. A body hoist is the recommended method for vehicle hoisting. When this hoist is used, raise vehicle using standard support procedures. Suspension will be supported in rebound by front and rear shock absorbers after vehicle is lifted. Also support vehicle at four corners with jackstands as a safety precaution. Do not use suspension hoists.
3. If a body hoist is not available, an alternate method approved for vehicle hoisting is to use a standard hydraulic floor jack. Raise front of vehicle at No. 2 crossmember until tires are above floor.
4. Support vehicle body with jackstands at each front corner and then lower floor jack so that front suspension is in full rebound. Repeat this procedure for rear air suspension, except raise body at rear jacking location.