Retrieve PID Information

This test is used to verify operation of input circuitry to the module being tested.
1. Perform Hookup and vehicle selection. Hookup and Vehicle Selection

NOTE: The ignition switch must be in RUN or test will fail.

2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "PID/Data Monitor and Record" and press trigger.
5. Select PID acronyms by rotating dial to highlight a PID and then press trigger. Repeat this process until all desired PIDs are selected. (* - indicates that a PID has been selected.)
6. Press Button 7 to view all selected PIDs.