Climate Control Assembly

REMOVAL




1. Remove battery ground cable.
2. Pull instrument panel moulding away from instrument panel far enough to remove electrical connectors. Remove instrument panel moulding.

NOTE: The instrument panel moulding is retained by snap-in tabs.

3. Remove four screws from the A/C control and pull the control out of the instrument panel.
4. Remove the two electrical connectors and the vacuum hose harness from the A/C control.

INSTALLATION
1. Connect the two electrical connectors and the vacuum connector to the A/C control.
2. Position the A/C control in the instrument panel and secure with four screws.
3. Install the instrument panel moulding by snapping in the bottom.
4. Connect battery ground cable.