Removal and Installation

REMOVAL

NOTE: Follow proper procedures.

1. Remove engine from vehicle.
2. Remove crankshaft (6303).
3. Clean and inspect cylinder block (6010), crankshaft, crankshaft main bearings (6333), crankshaft thrust main bearing (6337) and crankshaft thrust washer (6334).

INSTALLATION
1. Fit crankshaft main bearings. Fitting
2. Install upper crankshaft main bearing and crankshaft thrust washer into cylinder block. Install lower crankshaft main bearings and crankshaft thrust main bearing into main bearing caps.
3. Install crankshaft.
4. Install engine into vehicle.