EGR Electronic Vacuum Regulator Solenoid: Service and Repair

REMOVAL and INSTALLATION
1. Disconnect engine control sensor extension wire from EGR electronic vacuum regulator solenoid.
2. Disconnect main emission vacuum control connector from EGR electronic vacuum regulator solenoid.
3. Remove retaining nut and EGR electronic vacuum regulator solenoid from pressure feedback exhaust sensor mounting bracket located at rear of intake manifold.
4. To install, reverse Removal procedure. Tighten retaining nut for EGR electronic vacuum regulator solenoid to 5-7 Nm (40-61 lb in).