Transmission Range Indicator

REMOVAL
1. Remove instrument cluster.
2. Remove eight screws from instrument cluster main lens and instrument cluster mask.
3. Remove Engine Coolant Temperature Gauge and fuel gauge from instrument cluster.
4. Remove transmission range indicator from speedometer by releasing snaps.
5. Remove transmission range indicator.

INSTALLATION
1. Install the transmission range indicator to the speedometer and secure snaps.
2. Install the speedometer into the instrument cluster.
3. Install Engine Coolant Temperature Gauge and fuel gauge in instrument cluster.
4. Install eight screws retaining instrument cluster main lens and instrument cluster mask assembly.
5. Position the instrument cluster to the instrument panel. Connect the instrument cluster connector. Make sure transmission range cable is routed properly. Install the four cluster retaining screws.
6. Position the transmission range indicator column bracket to the steering column (locate pin in column slot) and adjust the transmission range indicator as follows:
a. Place the transmission selector lever arm and support on the steering column in the 1 position.
b. Place the loop on the indicator cable assembly over the retainer pin on the shift lever.
c. Secure cable bracket with screw.
d. Shift the transmission selector lever arm and support into the (D) position. Adjust the thumb wheel on the steering column so the entire width of the pointer falls within the letter (D).
e. When properly adjusted, the entire width of the pointer must fall within the width of the letter (D) and must touch the remaining letters or numerals when viewed parallel to the center line of the steering column tube from the driver's position.
7. Position the lower steering column shroud and install the retaining screws.
8. Connect battery ground cable.
9. Check operation of the instruments.