Door Glass Height Stop Adjustment

1. Remove front door trim panel and front door trim shield.
2. Lower front door window glass approximately 78 mm (3 inches) from full-up position.
3. Loosen nut and washer assemblies retaining the window regulator equalizer arm bracket to door inner panel.
4. Loosen nut and washer assembly retaining door window glass inner stabilizer.
8. With front door open, place hands on each side of front door window glass and pull front door window glass fully into front door glass top run at B-pillar.
6. Apply a downward pressure on the window regulator equalizer arm bracket and tighten nut and washer to 10-14 Nm (89-153 Lb-In).
7. Set door window glass inner stabilizer so that it is slightly touching front door window glass and tighten nut and washer assembly to 10-14 Nm (89-153 Lb-In).
8. Cycle front door window glass to verify proper operation.