Bezel

REMOVAL
1. Remove transmission control switch using a small screwdriver and gently prying between switch housing and transmission range selector lever knobs.
2. Remove retaining clip from transmission range selector lever knob.
3. Hold transmission range selector lever knob securely and press release button.
4. Pull up on transmission range selector lever knob and remove button and spring from lever knob.
5. Remove console finish panel.
6. Remove transmission control selector dial bezel retaining screws. Raise transmission control selector dial bezel and disconnect transmission range indicator lamp connector. Remove transmission control selector dial bezel.

INSTALLATION
1. Replace transmission control selector dial bezel over shift lever while lining up indicator slot with indicator driver.
2. Fasten retaining screws and connect the transmission range indicator lamp connector.
3. Position transmission range selector lever in PARK.
4. Position transmission control switch wiring connector against shift lever notch and hold while sliding transmission range selector lever assembly over transmission control switch wiring connector.
5. Install transmission range selector lever assembly into slide opening and press transmission range selector lever knob onto transmission range selector lever firmly.
6. Verify transmission range selector lever knob is installed completely onto lever and install retaining clip.
7. Install spring and button into selector lever knob.
8. Install transmission control switch into transmission range selector lever knob assembly.
9. Replace console finish panel.
10. Check transmission range selector lever for proper operation.
11. Check transmission control switch for proper operation. Instrument cluster indicator should indicate switch function.