Shift Cable: Service and Repair

REMOVAL
1. Remove console finish panel.
2. Remove screws retaining transmission control selector dial bezel to transmission range selector lever and housing.
3. Remove screws retaining transmission range selector lever and housing to floorpan.
4. Remove transmission shift cable and bracket-to-transmission range selector lever and housing retaining bolts. Disconnect cable from transmission range selector lever.
5. Raise vehicle on hoist.
6. Disconnect shift cable and bracket from transmission control selector connecting rod adjustment stud.
7. Remove retaining nut from shift cable and bracket to bracket at transmission.

INSTALLATION
Follow removal procedure in reverse order noting the following:
- Tighten shift cable and bracket nut to 13-25 Nm (10-18 ft. lbs.).
- Tighten shifter-to-floor pan bolts to 6-8 Nm (54-71 in. lbs.).
- Adjust transmission shift cable and tighten range selector lever-to-cable stud retaining nut to 17-23 Nm (13-16 ft. lbs.).