Spring Lock Coupling

REMOVAL

Fuel Tube Clip:

1. Remove clip from spring lock coupling.





2. Position Spring Look Coupling Disconnect Tool D87L-9280-A for 3/8 inch tube or D87L-9280-B for 1/2 inch tube or equivalent onto coupling. Make sure that tool can enter cage opening to release the garter spring.





3. Push the spring lock coupling disconnect tool into the cage opening to release the female fitting from the garter spring.





4. Pull the coupling male and female fillings apart.





5. Remove the spring lock coupling disconnect tool from the disconnected spring lock coupling.





6. Clean fittings with solvent.

NOTE: Inspect coupling for missing or damaged O-rings. If either O-ring is damaged both O-rings must be replaced. Replace O-rings or garter springs with the appropriate replacement parts only.

INSTALLATION
1. Lubricate the O-rings with clean engine oil.





2. Insert male filling into female filling and push together until garter spring is engaged.

Garter Spring:

3. Pull on fittings to verify coupling engagement.





4. Install clip to spring lock coupling.





5. Make sure clip is correctly installed.