Rear

REMOVAL
1. From inside luggage compartment, disconnect wheel sensor electrical connector located rearward of wheel well, behind carpeting on sides of luggage compartment.
2. Lift luggage compartment carpet and push sensor wire grommet through hole in luggage compartment floor.
3. Raise and support vehicle.

CAUTION: Do not bend clip open beyond the amount necessary to remove the clip from the axle housing.

4. Remove plastic clip holding sensor wire to rear axle housing.
5. Remove wheel sensor retaining bolt.

INSTALLATION
1. Align sensor locating tab and bolt hole to rear axle housing and push into position.
2. Install sensor retaining bolt and tighten to 4.5-6.8 Nm (40-60 inch lbs.).
3. Install plastic clip retaining sensor wire to rear axle housing and push electrical connector through hole in floor into luggage compartment. Make sure rubber grommet is properly seated in hole in floor.
4. Lower vehicle.
5. Connect sensor electrical connector to connector on harness.
6. Retest brake system.