Rear Disc

REMOVAL
1. Raise and support vehicle..
2. Remove cable tension. Tension Release
3. Disconnect rear front parking brake cable and conduit end from tensioner or parking brake intermediate cable/front parking brake cable at cable connector.
4. Remove parking brake rear cable and conduit snap-in from inner floor side member bracket using a 13 mm 12-point box-end wrench to press retaining prongs.
5. Disconnect parking brake rear cable and conduit end from caliper housing and remove cable from parking brake lever arm on caliper.
6. Remove front parking brake cable retainer from rear stabilizer bar.

INSTALLATION
1. Route parking brake rear cable and conduit and secure parking brake rear cable and conduit to rear disc brake caliper and frame bracket.
2. Connect parking brake rear cable and conduit end to tensioner or parking brake intermediate cable/ front parking brake cable and conduit at cable connector.
3. Release tensioner.
4. Adjust parking brake cable. Adjustments
5. Install cable retainer to rear stabilizer bar.
6. Retest brake system.