With 16 Inch Wheels

FRONT
Front disc brakes use a pin slider-type disc brake caliper assembly with a 294 mm (11.57 inch) full cast front disc brake rotor.
^ The disc brake caliper has a caliper piston with a piston seal and a press-in type dust boot.
^ The disc brake caliper assembly is retained to the front disc brake caliper anchor plate with two brake pin retainers.
^ The front disc brake caliper anchor plate is attached to the front wheel spindle by two M 12 X 1.75 X 30 mm bolts. Using longer bolts will damage the front disc brake rotor.
^ Rubber insulators isolate the disc brake caliper locating pins from direct contact with the disc brake caliper.
^ The brake hose inlet port thread size is M 10 X 1.5.

REAR
The rear disc brake caliper assembly consists of:
^ caliper housing with single rear disc brake piston and adjuster and parking brake mechanism
^ inner and outer rear brake shoes and linings
^ rear disc support bracket
^ two lubricated disc brake caliper locating pins that position rear disc brake piston and adjuster relative to rear disc support bracket.
^ rubber slide pin boot seals that prevent lubrication
^ washout and corrosion of disc brake caliper