Knock Sensor: Service and Repair

Knock Sensor:

REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Raise vehicle on hoist.
3. Disconnect engine control sensor wiring from Knock Sensor (KS).
4. Remove knock sensor from cylinder block.
5. To install, reverse Removal procedure. Tighten knock sensor to 15-20 Nm (11-15 lb ft).