Retrieve PID Information

NOTE: This test is used to verify operation of input circuitry to the module being tested. The ignition switch must be in RUN position or test will fail.

1. Perform New Generation Star Tester hookup and vehicle selection. Refer to New Generation Star Tester Useage.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "PID/Data Monitor and Record", press trigger.
5. Select PID acronyms by rotating dial to highlight a PID and then press trigger. Repeat this process until all PIDs are selected. (* - indicates that a PID has been selected.)
6. Press Button 7 to view all selected PIDs.