Shifter A/T: Service and Repair

REMOVAL
1. Raise and support vehicle.
2. Remove center underbody heat shield retaining nuts.
3. Disconnect shift cable and bracket from transaxle range selector lever stud.
4. Remove four bracket retaining nuts.
5. Remove bracket with transaxle shift cable connected, then position aside.
6. Lower vehicle.
7. Using a screwdriver pry bezel from console assembly.
8. Lift gearshift lever out of console assembly to access transaxle control switch wiring harness connector.
9. Disconnect transaxle control switch wiring harness connector, then remove gearshift lever.

INSTALLATION
1. Reverse procedure to install.