C1671-2: Check Anti-Lock Brake Indicator

- If connected, remove breakout box and anti-lock brake module adapter cable.

- Reconnect hydraulic control unit. Make sure all connections are clean and tight.

- Start engine and observe anti-lock brake warning indicator.

- Is indicator illuminated after 5-10 seconds?

YES -- Replace anti-lock brake relay. Go to C1671-3. C1671-3: Check Anti-Lock Brake Control Module

NO -- The fault was intermittent. The ABS and traction control system (if equipped) should be considered operational at this time and no further action required. Clear all DTCs.