Hook-Up

New Generation Star Hook-Up With Adapter Cable Assembly:

The scan tool must be connected to the Data Link Connector (DLC) for communication between the vehicle computers and the scan tool. If the New Generation Star (NGS) is used to communicate with the vehicle, an OBD II adapter cable must be connected to the tool. Refer to the NGS owner's manual for specific information.


New Generation Star (NGS)
- Key OFF.
- Verify that the proper memory (EPROM) card is inserted in the NGS.
- Connect J1962/16 Pin OBD II DLC cable adapter to the NGS.
- Connect NGS DLC cable adapter securely into the vehicle DLC.
- Connect the NGS power supply cable to vehicle.
- Turn ignition key to the ON position or start vehicle if necessary. The NGS is ready to communicate with vehicle computers.
- Follow instructions on the scan tool screen display or in the diagnostic manual.
- To disconnect tool, turn ignition key to the OFF position and disconnect scan tool from DLC and power supply.