Instrument Panel - Defroster Grill Finish Panel

REMOVAL and INSTALLATION

NOTE: Protect instrument panel surface during this procedure.

1. Using putty knife or similar tool, insert under LH or RH corner of the instrument panel defroster opening grille and pry up to release one snap clip.
2. Unsnap the remaining four clips by pulling up by hand, working toward opposite side of vehicle.
3. Disconnect A/C sunload sensor wiring connector (if equipped).
4. To install, make sure the five locator tabs on the front of the instrument panel defroster opening grille are installed in the slots. Then press down to snap in place.