Rear Safety Belt Retractor and Tongue
Removal1. Remove the radio speaker grille.
2. Remove the quarter trim panel. For wagon models, also remove the C-pillar trim panel.
3. Remove the rear safety belt retractor bolt(s).
4. Remove the rear safety belt guide bolt.
5. Pull up the rear seat cushion to gain access to the rear safety
belt anchor.
6. Remove the safety belt anchor bolt and remove the assembly.
Installation
To install, reverse the removal procedure. Tighten rear safety belt retractor bolt(s), the rear safety belt guide bolt, and the safety belt anchor bolt to 30-40 N.m (22-30 lb-ft).