Passenger's Side

REMOVAL

WARNING: THE BACKUP POWER SUPPLY ENERGY MUST BE DEPLETED BEFORE ANY AIR BAG COMPONENT SERVICE IS PERFORMED.

1. Disconnect the battery ground cable and wait one minute for the backup power supply energy to be depleted.





2. Remove two glove compartment to instrument panel hinge attaching screws, then the glove compartment.





3. Remove two passenger's air bag module attaching bolts.
4. Lift passenger's air bag module from instrument panel, then disconnect electrical connector.

INSTALLATION
1. Press air bag module mounting tabs in instrument panel down slightly, then connect module electrical connector and position module in instrument panel.
2. Install two air bag module bolts. Tighten attaching bolts to 60-78 in lb.
3. Install glove compartment in instrument panel.
4. Connect the battery ground cable.
5. Turn the ignition key to ON to verify that the air bag indicator is functioning properly.