Center Rear Belt Assembly - Sedan

REMOVAL
1. Remove rear seat back and cushion.
2. Remove the panel.
3. Remove rear safety belt and buckle anchor nut and remove rear safety belt and buckle.
4. Remove rear safety belt and buckle anchor nut and remove rear safety belt and buckle.

INSTALLATION
1. To install, reverse removal procedure. Position safety belts and retractor as shown.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten all anchor nuts to 30-40 Nm (22-30 lb ft).
4. Check the restraint system for proper operation.