Split Bench Seat

REMOVAL
1. Remove passenger split bench safety belt nut.
2. Remove driver split bench safety belt nut.
3. Remove LH front seat center passenger belt assembly.
4. Remove driver split bench seat.
5. Remove split bench safety belt anchor nut from RH front safety belt buckle end assembly. On RH side, disconnect safety belt warning chime wire and pry locator off the seat.
6. Remove passenger split bench seat.
7. Remove split bench safety belt anchor nut from LH front safety belt buckle end assembly. On LH side, disconnect safety belt warning chime wire and pry locator off the seat.

INSTALLATION
1. To install, reverse removal procedure. Position RH front safety belt buckle end assembly and LH front safety belt buckle end as shown.
2. Make sure safety belt webbing is not twisted. If it is, remove the twist.
3. Install two split bench safety belt nuts. Tighten to 68-92 Nm (50-68 lb ft).
4. Install two split bench safety belt anchor nuts. Tighten to 30-40 Nm (22-30 lb ft).
5. Check the restraint system for proper operation.