With Analog Cluster

A lamp outage is sensed by measuring the change in voltage drop across a special section of the wiring harness.

CAUTION: Do not alter lengths of these wires, unless otherwise directed. Do not hook up additional lamps (i.e. trailer tow lamps). Do not replace bulbs with any type different from original equipment. Doing so may result in a false warning or no warning.

The unique wiring harnesses associated with the lamp-out warning system use special resistance wire for proper system operation.

The lamp out warning system consists of:
1. Lamp out control module.
2. Unique wiring harness.
3. One warning indicator.

The lamp out warning system monitors three functions:
1. Low-beam headlamps.
2. Rear parking lamps.
3. Brake lamps.
The system operates when the ignition switch is in ACC or RUN.

HEADLAMP OUT
LAMP OUT: Combines the functions of REAR LAMP OUT and HEADLAMP OUT.

TAIL LAMP OUT
LAMP OUT: Combines the functions of REAR LAMP OUT and HEADLAMP OUT.

BRAKE LAMP OUT
LAMP OUT: Combines the functions of REAR LAMP OUT and HEADLAMP OUT.