Auxiliary Seat Belts - Wagon

REMOVAL
1. Remove nut to remove auxiliary safety belt and buckle assembly.
2. Remove rear seat back.
3. Remove three screws retaining stowage compartment door and hinge.
4. Remove stowage compartment door and hinge. Reach between rear floor pan and load floor and remove the nut to pull out the retractor.

INSTALLATION
1. To install, reverse removal procedure. Position belts as shown.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten anchor nuts to 60-90 Nm (44-66 lb ft).
4. Check the restraint system for proper operation.