Removal and Installation

REMOVAL
1. Disconnect battery ground cable.
2. Remove the instrument cluster.
3. Remove seven screws retaining the instrument cluster mask and instrument cluster warning lamp lens assembly.
4. Detach speed control speedometer cable and remove speedometer assembly.

INSTALLATION

Speedometer Cable Installation And Routing:

1. Position the speedometer assembly to the backplate, attach speed control speedometer cable and install.
2. Position the instrument cluster mask and instrument cluster warning lamp lens assembly to the backplate and install the seven retaining screws.
3. Install the instrument cluster.
4. Connect battery ground cable and check the operation of the speedometer.

NOTE: Because of the increasing complexity of speed control cable and vehicle speed sensor assemblies and the importance of proper routing during installation, installation and routing instructions are shown on the Speedometer Cable Installation And Routing illustration.