With Floor Shift

REMOVAL
1. Remove instrument cluster finish panel retaining screws and remove instrument panel finish panel.
2. On vehicles with tachometer, remove lower trim panel retaining screws and remove trim panel.
3. Remove eight mask-and-lens mounting screws and remove instrument cluster mask and instrument cluster warning lamp lens.
4. On vehicles with tachometer, remove two lower flood lamp bulb and socket assemblies.
5. Lift main dial assembly from instrument cluster back plate.

NOTE: The gauges are mounted to main dial, and some effort may be required to pull quick-connect electrical terminals from clips.

NOTE: Lower flood lamp bulb filters are not secured and may fall out.

6. Manually rotate the gauge pointer to align it with slot in dial. Remove mounting screws and carefully pull fuel gauge away from dial, guiding pointer through slot.

INSTALLATION
1. Carefully position pointer parallel to rectangular raised portion of dial.

CAUTION: The gauges are calibrated at the factory. Excessive rough handling could disturb the calibration.

2. Guide the pointer carefully through slot in main dial. Then position the gauge on mounting bosses and install mounting screws. Tighten screws to 0.8-1.4 Nm (8-12 lb-in).
3. Install main dial assembly to instrument cluster back plate by aligning it on guides. Press carefully and firmly to seat all electrical terminals.
4. On vehicles with tachometer, install two lower flood lamp bulb and socket assemblies.

NOTE: Lower flood lamp bulb filters are not secured and may fall out.

5. Position mask-and-lens assembly and install eight instrument cluster mask and instrument cluster warning lamp lenses retaining screws.
6. On vehicles with tachometer, install lower trim panel.
7. Install instrument panel finish panel.