Throttle Position Sensor: Service and Repair

Throttle Position Sensor:

REMOVAL

1. Disconnect battery ground cable.

2. Remove water pump pulley shield.

3. Disconnect fuel charging wiring from Throttle Position (TP) sensor.

4. Remove two TP sensor retaining screws.

5. Remove TP sensor.

INSTALLATION

1. Install TP sensor. Ensure that rotary tangs on sensor are in proper alignment.

CAUTION: Slide rotary tangs into position over throttle shaft blade, then rotate TP sensor clockwise to installed position only. Failure to install the TP sensor in this manner may result in possible damage to the TP sensor or excessive idle speeds.

2. Secure TP sensor to throttle body with two retaining screws. Tighten to 2.8-3.8 Nm (25-34 in lb).

NOTE: This TP sensor is not adjustable.

3. Connect fuel charging wiring to TP sensor.

4. Install water pump pulley shield. Tighten retaining screws securely.

5. Connect battery ground cable.