NC8 - Check ICM

- Key "OFF".

- Breakout box installed.

- Connect Powertrain Control Module (PCM) to breakout box.

- Ignition Control Module (ICM) connected.

- Connect Digital Volt/Ohm Meter (DVOM) between test pin 4 and test pin 16 at the breakout box.

- Start engine.

- Observe DVOM when voltage is allowed to stabilize.

- Lightly tap on electronic ignition components (to simulate road shock).

- Wiggle both ICM connectors.

- A sudden change in voltage indicates a fault.

- Is a fault indicated?

Yes -- Disconnect and Inspect connectors. If connector and terminals are good, remove breakout box, reconnect all components and refer to Ignition Systems.

No -- Go to NC9. NC9 - Check EEC-IV Harness