Removal and Replacement

REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.

NOTE: When the battery has been disconnected or reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Remove right hand cowl side trim panel to expose PCM.
3. Loosen engine control sensor wiring to PCM connector retainer bolt.
4. Remove engine control sensor wiring connector from PCM.
5. Remove PCM from bracket by pulling PCM downward.
6. Reverse Removal procedure. Tighten engine control sensor wiring connector retainer bolt to 2.7-3.7 Nm (24-32 in lb).